全自动粒子钢热熔压块机详细介绍

鑫虎钢渣粒子钢液压压制成型系统的技术优势

Technical Advantages of Hydraulic Pressing Molding System for Steel Slag Particle Steel

1、粒子钢铁水降低率低

Low reduction rate of particulate molten iron and steel

系统采用特殊调节手段对粒子钢上料、液压压制成型等方面进行自动化控制，粒子钢在此过程中氧化率很低，因此与原料相比，粒子钢成型后含铁量降低幅度可以控制在2%以下。全自动粒子钢热熔压块机

Particle steel feeding and hydraulic pressing are controlled automatically and accurately by special adjusting means. The oxidation rate of particle steel is very low in this process. Therefore, compared with raw materials, the reduction of iron content after particle steel forming can be controlled below 2%.

2、粒子钢质量耗损率低全自动粒子钢热熔压块机

Low mass loss rate of particulate steel

此设备采用高效收尘措施，小粒级粒子钢直接返回烘干二段，且系统封闭性较好，因此，系统粒子钢几乎没有损耗。

This equipment adopts high efficiency dust collection measures, small particle steel directly returns to the second drying stage, and the system has good closure, so the system particle steel has almost no loss.

3、系统降低能耗

System Reduction of Energy Consumption

系统采用全自动化进行控制，对生产过程中的各个环节进行控制和***的液压伺服装置，在运行过程中电耗低，系统总功率比常规系统降低20%左右。

The system uses full automation for precise control, precise control of all links in the production process and advanced hydraulic servo device. In the operation process, the power consumption is low, and the total power of the system is reduced by about 20% compared with the conventional system.

 4、系统造价较低全自动粒子钢热熔压块机

Lower system cost

系统设计中将烘干过程分级设计，系统尺寸大幅度降低，与常规设计相比，本系统造价降低约30%左右。

In the design of the system, the drying process is graded and the size of the system is greatly reduced. Compared with the conventional design, the cost of the system is reduced by about 30%.

5、系统事故率低

 Low system accident rate

通过模拟计算和自动化系统预警和调节，设备某一环节出现故障或系统检测传感器参数有异常时会及时进行报警和优化设备运行，系统作业率大幅度上升。全自动粒子钢热熔压块机

Through analog calculation and automatic system early warning and adjustment, the system will alarm and optimize the operation of the equipment in time when a fault occurs in a part of the equipment or the parameters of the system detection sensor are abnormal, and the operation rate of the system will increase greatly.

6、   系统流程简单，运行稳定性好

The system process is simple and the operation stability is good.

系统流程设计非常简洁、顺畅，调节手段灵活，系统运行稳定性很高。全自动粒子钢热熔压块机

System flow design is very simple, smooth, flexible means of regulation, system operation stability is very high.